3 OHM PDM FILTER

Welcome and feel free to ask questions about class E, mosfet's, and AM.
You must be registered to post.

3 OHM PDM FILTER

Postby frank carcia » Tue Feb 25, 2003 4:23 pm

Hi All,
I did some Micro Cap simulation and learned that 3 filter sections are required when you get above a couple ohms of final load Z. I picked 3
ohms because below that my present filter works with 2 sections.
Starting at the modulator the three inductor values are 48 UH, 32 UH and
24 UH at the final. The 3 cap values are 8 UF, 6 UF and 3 UF at the final.
The performance is 75 dB attenuation at 85 KHz. The roll off is a nice slope starting around 10 HKz. The student version of Micro Cap works very well. We only have a few licenses here at work so free is very
nice. It was pretty easy to use. I picked 1/10 ohm drive Z. I can saved
the set up if anyone needs values for different loads. fc
frank carcia
Senior Contributer
 
Posts: 765
Joined: Fri Jan 31, 2003 10:48 am
Location: Enfield Ct. / Niantic Ct.

Return to Class E Discussion

Who is online

Users browsing this forum: No registered users and 1 guest

cron